Climax CTC-1052-QT, Руководство пользователя

Страница: 22 / 58

18
the Monitoring Center by sending out a
speech report.

When speech report is set to ( 0 ), press any
DTMF key for panel to regard speech reporting
successful
.

When speech reporting is set to ( 1 ), off-hook
phone for panel to regard speech reporting
successful.

Factory default is ( 0 ), Any DTMF.
Function Selection Result
(0) Any DTMF
(1) OFF-HOOK
Command 80-82
Remove Devices
 CTC-1052-QT can be programmed to
remove
ALL previously learnt devices by
entering ( 80) followed by (
＃
).
After entering command ( 80 ) (
＃
), the
system will immediately emit an
acknowledging beep over the phone.
Continue to hold the phone set until you
hear the second acknowledging beep after
12 seconds.
 Command 81 is used to remove Zone 1
device.
 Command 82 is used to remove Zone 2
device.
Command 93
Learn-In Silent Pendant
<NOTE>

This command is not available in
Remote Programming Mode.

Only one Silent Pendant can be learnt into
CTC-1052-QT by using Command #93.

For learning Silent Pendant :
Step 1: Enter 93 + # on the phone set, then
a short beep will be heard via the
phone set. (If no command is dialed,
CTC-1052-QT will exit Programming
mode automatically and return to
idle mode).
Step 2: Press the Pendant Button within 20
seconds.

Learning can only be completed
within the signal reception range of
CTC-1052-QT.

If no signal is received within 20
secs, CTC-1052-QT will emit a long
beep and automatically returns to
Programming mode.
Step 3: CTC-1052-QT will emit 2 beeps to
indicate that Silent Pendant is learnt-
in successfully.

Adding a Pendant for a second time
is prohibited unless it is removed
from the system first.

If one long beep is emitted instead
of 2 beeps, it indicates:
 The device has already been
learnt-in.

Another device has been learnt-in
before.
<NOTE>

When CTC-1052-QT received the
alarm signal from the Silent Pendant, it
will not emit any warning beeps during
Reporting and Guard time period.
Command 94
Learn-In Device
<NOTE>

This command is not available in
Remote Programming Mode.

Up to 20 devices can be learnt into CTC-
1052-QT by using Command #94.

The available devices that can be learnt-in
Command #94 are:
 PIR Sensor ----- PIR
 Smoke Detector ---- SD
 Carbon Monoxide ---- CO
 Fixed Panic Button ---- PB
 Wrist Transmitter ---- WTR
 Pendant Transmitter ---- WTR
 Water Sensor ---- WS
 Fall Sensor
Step 1: Enter 94 + # on the phone set, then