User-Selectable Features (Customer Mode):
1 beep = OFF, 2 beeps= ON
Feature Select
Right x 1
Left x 1
Beeps:
off
/on/soft (
1
/2/3 beeps)
Left x 2
AutoArming:
off
/on
Left x 3
AutoArming entry delay:
off
/on
Left x 4
Siren duration:
30
/60/90sec. (
1
/2/3 beeps)
Left x 5
FACT anti-falsing: off/
on
Left x 6
Reset all features to stock (except valet code)
Left x 7
Set a new secret valet code
NOTE 1
Installer-Programmable Features
1. Turn on the ignition.
2. Enter the factory preset valet/programming code of “2” by toggling the valet switch
(located behind the LED assembly) to the left two times, then to the right.
3. Hold the switch to the left. You’ll hear one beep after about 3 seconds to indicate user
programming mode.
KEEP HOLDING
(about 12 more seconds) until you hear the
3-beep installer programming mode confirmation.
4. Select the feature column: Toggle the switch to the right the number of times indicated
for the column. Pause. You will hear the same number of horn beeps, confirming your
selection.
5. Within five seconds, select the feature row: Toggle the switch to the left the number of
times indicated for the row. You’ll hear a beep each time to help you count.
6. If there is a NOTE for the selected feature, perform the actions noted.
7. Pause. You will hear either one or two beeps: two beeps = ON, one beep = OFF.
8. You can select another feature, or you can exit program mode:
a. To select another feature in that same column, repeat step 5 within the next five
seconds (after five seconds, three beeps indicate return to the
“
Feature Select
”
position).
b. To select a different feature column, repeat step 4.
c. To exit program mode, turn the ignition off (you’ll hear three beeps and the LED will
turn off), or wait 60 seconds for the system to automatically exit program mode.
Installer-Programmable Features: 1 beep = OFF, 2 beeps = ON
Feature Select
Right x 1
Right x 2
Left x 1
Door Ajar Warning
/Delayed Courtesy
Lights (
1 beep
/2 beeps)
Sleep Mode
(On/
Off
)
Left x 2
NOT USED
Accessory Output A type:
Pulsed
/Timed (
1 beep
/2 beeps)
Left x 3
NOT USED
Positive
/Negative
Door Trigger (1 beep/
2 beeps
)
Left x 4
NOT USED
NOT USED
Left x 5
NOT USED
NOT USED
Left x 6
Opt. Siren/
Car Horn
(1 beep/
2 beeps
)
Accessory Output Timer Duration
(
10sec.
): 1-255 sec.
NOTE A
n
NOTE A: A chirp will indicate the timer has started. When the desired duration has been reached
(1-255 seconds), tap the valet switch to the right (2 chirps).
7
n
NOTE 1: Immediately toggle
right, then enter the new code,
wait for the two beeps, then
turn off the ignition (3 beeps).
You MUST now turn the
ignition back on and re-enter
the new code. If the LED
flashes on, the new code is set.
If it does not, the two codes did
not match and the system has
reverted to the previous code.
8
D:...-923 Level 3 install manual.vp
Mon Aug 02 10:56:54 1999
Color profile: Disabled
Composite Default screen
