Eight-Event TotalRecall
1. With the ignition OFF, press and hold the valet switch (at the rear of the LED assembly)
to the right.
2. Use the remote control to lock, then unlock, then release the valet switch.
3. The LED will flash 2–7 times, pause, then flash 2–7 times, etc.
4. Refer to the following chart. The first set of flashes was the most recently activated trigger
or sensor. The next is the second most recent, and so on up to as many as the last eight.
CliffNet Wizard PRO provides an on-screen written report of these activations.
LED flashes
Trigger/sensor indication
2 flashes
Optional Sensor
4 flashes
Door trigger
5 flashes
Optional trunk trigger
6 flashes
Hood trigger (if IntelliStart 4 is installed)
7 flashes
An attempt was made to turn on the ignition while the system was armed
Programmable Features
The Level THREE comes preprogrammed as noted in
bold
text in the following tables.
Using CliffNet Wizard PRO
The CliffNet Wizard PRO software provides an intuitive access to all installer and end-user
features through a user-friendly, graphical user interface and provides extensive diagnostic
capabilities. See
www.clifforddealer.com
to download a free copy of the program (a #60-509
cable set is required to connect your Windows PC or palmtop to the G4 DataPort).
Programming User-Selectable Features
1. Turn the ignition to the “ON” position or start the engine.
2. Enter the factory preset valet/programming code of “2” by toggling the valet switch
(located behind the LED assembly) to the left two times, then to the right (LED on).
3. Immediately hold to the left for about 3 seconds until you hear one horn beep* and the
LED turns on to confirm the system is in the “Feature Select” position.
4. Toggle the switch to the right once, then pause. Pause. You will hear a confirmation beep.
5. Within five seconds, select the feature by toggling the switch to the left the number of
times indicated. You’ll hear a beep each time to help you count.
6. If there is a NOTE for the selected feature, perform the actions noted.
7. Pause. You will hear either one or two beeps: two beeps = ON, one beep = OFF.
8. You can select another feature, or you can exit program mode:
a. To select another feature, repeat step 5 within the next five seconds (after five seconds,
three beeps indicate return to step 4).
b. To exit program mode, turn the ignition off (you’ll hear three beeps and the LED will
turn off), or wait 60 seconds for the system to automatically exit program mode.
* system horn connection required for confirmation beeps
6
7
D:...-923 Level 3 install manual.vp
Mon Aug 02 10:56:53 1999
Color profile: Disabled
Composite Default screen
