Optional Dual-Zone Piezo Vibration/Impact Sensor
Mount the sensor in the passenger compartment, not in the engine compartment.
1. Firmly mount the sensor near the base of the steering column (if the steering column has a
rotating sleeve, firmly screw the sensor to the interior firewall, kick panel or trunk wall).
2. Mate the sensor to the connector with the ORANGE, BLUE, BLACK and RED wires.
3. After power-up, adjust sensitivity as noted in the instructions that come with the sensor.
Auxiliary A Output
The Auxiliary A output (GRAY/VIOLET wire) is activated by pressing the factory remote
LOCK
button three times (or pressing the vehicle’s lock switch three times). This output can
be programmed as either pulsed or timed. The factory setting is pulsed output (1 second
ground). Current is limited to 0.15 amp.
European Vehicle Window/Sunroof All-Close
If turning and holding the door key closes the power windows/sunroof (a common feature on
European vehicles), you can make the following connections to provide window/sunroof
closure upon triple-locking:
1. Find the wire that shows +12V or ground when the key is held to lock in the door cylinder.
2. Tap a wire in to this wire and connect to terminal 30 of a relay.
3. If the wire shows ground when the key is turned, connect terminal 87 to ground; if +12V,
connect terminal 87 to 12V.
4. Connect the GRAY/VIOLET wire to terminal 85.
5. Connect terminal 86 to +12V.
6. After power-up, program Auxiliary A to timed output.
7. Program the timer to 2 seconds longer than the time it takes to close all windows/sunroof.
Remote Timed Headlight Activation
You can provide timed headlight activation upon triple-locking. Simply follow the steps
above using the wire that shows +12V or ground when the headlight switch is activated.
Optional Engine Compartment Connections
Optional Siren
Mount the siren in the engine compartment away from hot or moving parts and where it
cannot be reached from under the vehicle. Point downward to avoid water collection.
1. Firmly secure the siren to the engine bay firewall or a fender well.
2. Connect the YELLOW wire to the siren’s BLACK ground input.
3. Connect the siren’s RED wire to the system’s 5-amp pre-fused RED wire.
4. After power-up, program the horn/siren output for siren (factory setting is for horn).
Final Wiring Connections
1. Attach the fuseholder of the RED wire to a co12V supply.
2. Connect the BLACK wire to a grounding bolt (clean to ensure a solid ground).
3. Insert the 5-amp fuse into the RED wire’s fuseholder.
NOTE: Power and test accessories after the basic system has been tested.
Individually fuse all accessory power and fuse panel connections.
Delayed Courtesy Lights
Delayed or dimming courtesy lights interfere with remote arming. If the delay is more than 5
seconds, turn on the
Delayed Courtesy Lights
feature noted on page 7.
5
6
D:...-923 Level 3 install manual.vp
Mon Aug 02 10:56:52 1999
Color profile: Disabled
Composite Default screen
