Clifford Model RSX1.2, Руководство по установке

Страница: 17 / 42

© 2004 Directed Electronics, Inc. Vista, CA
1 17 7
aauuxxiilliiaarryy hhaarrnneessss ((HH22)) wwiirree ccoonnnneeccttiioonn gguuiiddee
This wire sends a negative pulse every time the remote start is activated or the doors are unlocked. This can be
used to pulse the disarm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to
the disarm wire as shown in the following diagrams.
R Reellaayy ffo orr N Neeg gaattiivvee ((--)) D Diissaarrm m W Wiirree R Reellaayy ffo orr P Po ossiittiivvee ((+ +)) D Diissaarrm m W Wiirree
Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dash-
board. In most diesels the wire is negative (ground turns on the bulb) and the GRAY/BLACK can be directly
connected to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the bulb) a relay must
be used to change the polarity. (See Finding the Wait-To-Start Bulb Wire For Diesels section of this guide.) Here
are some common colors of this wire:
■
Chevrolet and GMC trucks: Light Blue or Dark Blue
■
Ford Trucks: Black/Pink
■
Dodge Ram Trucks: Orange/Black or Black/Orange
N NO OTTEE!! A 1-amp diode must be installed in line on the factory wire between the wait-to-start indi-
cator and the ECM. (See the following diagram for details.)
H H2 2//2 2 G GR RA AY Y//B BLLA ACCK K ((--)) d diieesseell w waaiitt--tto o--ssttaarrtt b bu ullb b iin np pu utt
H H2 2//1 1 G GR REEEEN N//B BLLA ACCK K ((--)) ffaacctto orryy aallaarrm m d diissaarrm m