www.clifford.com
19
2-6 DOOR TRIGGER ERROR CHIRP ON/OFF:
With the door trigger error chirp programmed
off, the system will not report an invalid zone on arming when the door trigger wire is active. This
eliminates the extra chirps that occur when interfacing with vehicles that have exceptionally long
dome light delay circuits.
2-7 IGNITION-CONTROLLED DOMELIGHT SUPERVISION ON/OFF:
If turned on, the
system will turn on the domelight for 30 seconds when the ignition is turned off. The optional
domelight supervision feature must be installed.
2-8 DOUBLE PULSE UNLOCK ON/OFF:
Some vehicles require two pulses on a single wire to
unlock the doors. When the double pulse unlock feature is turned on, the BLUE H2/C wire will
supply two negative pulses instead of a single pulse. At the same time, the GREEN H2/A wire will
supply two positive pulses instead of a single pulse. This makes it possible to directly interface with
double pulse vehicles without any extra parts.
2-9 CHANNEL 3 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30 SECOND
TIMED/SECOND UNLOCK OUTPUT:
Channel 3 can be programmed for these output configu-
rations. The unit is set to the default validity output. To change the configuration, use the two-chirp
setting to toggle to the different configurations. (Refer to the H1/3 WHITE/BLUE wire description
in the
Primary Harness (H1) Wire Connection Guide
section of this guide.)
Transmitter/Receiver Learn Routine
The system comes with two transmitters that have been taught to the receiver. The receiver can store
up to four different transmitter codes in memory. Use the following learn routine to add trans-
mitters to the system or to change button assignments if desired.
If the Directed Bitwriter or PC Interface has previously been used to program the system,
the unit may have been locked, so that the features and channels cannot be altered via
manual programming with the Valet switch. If the siren generates one long chirp when attempting
to program the transmitter/receiver, this indicates that the unit is locked. You must unlock it with
the Bitwriter or PC Interface before you will be able to manually program the transmitter/receiver.
NOTE: The transmitters cannot be programmed using the Bitwriter or the PC Interface.
