Cleveland WELBILT MFS, Руководство пользователя, Страница: 11 / 29

ASSEMBLY
NOTE: To eliminate any chance of recontamination of unit,
wear sanitary disposable gloves during reassembly after
cleaning.
This assembly procedure assumes the unit is fully
disassembled.
1.
Attach Product Cylinder to Piston Cylinder
as follows
:
Þ
Inspect Product Piston "O" Ring (replace if worn) on
Product Piston - lubricate with food grade grease.
Þ
Push Product Cylinder over Product Piston and seat
firmly in groove.
2.
Assemble Piston Head Assembly as follows in order:
Þ
Inspect Flapper Valve "O" ring on rotary actuator
(replace if worn).
Þ
Lubricate "O" ring with food grade grease and put on
shaft.
Þ
Put Spring on Shaft.
Þ
Slide Rotary Actuator Shaft thru hole in Piston Head.
Þ
Mount Flapper to Shaft.
3.
Assemble piston and piping as follows in order:
NOTE : Use 2" gaskets in all hex nut couplings.
Þ
Put Cylinder Seal in place. Lubricate exposed portion
of Cylinder Seal then mount Piston Head to Product
Cylinder, and fasten in place with large Lug Nuts using
lug wrench for final tightening.
Þ
Attach two 1/4" air lines to Rotary Actuator (black line
on top).
Þ
Reassemble 2" piping on Piston Head as illustrated
using gaskets and saniclamps.
4.
Assemble discharge head assembly in order as follows:
Þ
Inspect and install "O" Rings (replace if worn) on
Plunger - larger one in top groove - smaller one in
bottom groove.
Þ
Applhy sufficient food grade grease on the plunger
Þ
Push Plunger into Discharge Valve Body.
Þ
Attach Discharge Valve to Discharge Valve Body
using 2" Sani-Clamp.
Þ
Attach Discharge Nozzle to Discharge Valve Body
Product Cylinder
Push
Pin
Air Cylinder
Product Piston
Product Piston "O" Ring
Flapper Valve
"O" Ring
Spring
Flapper
Rotary Actuator
Shaft
Piston Head
Product Cylinder Piston Head
Short
2" dia.
Pipe
2" dia. Elbow
Long
2" dia.
Pipe
Cylinder
Seal
Lug Nut
Gasket
Gasket
Gasket
Discharge
Valve
Plunger
Discharge
Valve
Body
2" Sani
Clamps
"O" Rings
10