Cleveland CE-400 Series, Руководство по эксплуатации, Страница: 13 / 17

CE-400 Series Label Shrinking Machines
Page
12
VIII
．
CAUTION
1.
The electrical input power rate must be higher than the Rated power of the
machine to ensure proper function. The power source must be the same as noted
on the tag to avoid any circuitry or electrical shock or fire hazard.
2.
The electricity wires must be connected properly; otherwise it makes damage
to machine and operator. When the power is 3 phases (4 wires) as noted on the tag,
it must input the null wire, or the mach ine can’t work normally and easy to burn the
electronics.
3.
The machine must do the earth connection. It is easy to get electric shock for
operator without earth connection.
4.
Do not set temp. above 200
℃
, or damage heating pipes or shorten its life.
5.
The machine should be placed level; otherwise it will reduce the life of heating
pipe.
6.
During working, carbon brush in motor wears off. It is only for CE-425. So check
carbon brush in every half year. Replace it carbon brush when it wears out. If not,
motor will damage. Clean powder of carbon brush in motor while replacing.
7.
Every three months, check the wire and heating pipe in the tunnel because it
is get aging and burned by heat from shrink tunnel; replace it if it is necessary.
8.
Do not touch conveyor or stretch hands into shrink tunnel to keep from
burning, while the machine is working.