Cleveland CE-400 Series, Руководство по эксплуатации, Страница: 10 / 17

CE-400 Series Label Shrinking Machines
Page
9
VI
．
OPERATIONAL PROCESS
1.
Place the machine on the level ground and unpack it; make sure
to complete the ground connection for the safety of operator. (Notice:
Grounding plate is displayed in the picture on the right; it can be found
on one of 3 power wires if it is single phase; it can be found on the
body of machine if it is 3 phase with 4 power wires)
2.
Do the relevant adjustment to different model machine.
✓
CE-435: CE-435 must be connected with conveyor or production line correctly.
The bottle is able to pass through tunnel smoothly and is in the middle of
position. In order to reduce loss of heat, try to enable tunnel to be close to
conveyor.
✓
CE-415: The height of CE-415 is decided by height of bottle. Loosen the nuts
and adjust shrink tunnel to be about 5cm higher than bottle; make sure that it
is in a horizontally level position; retighten the nuts to secure height position.
✓
CE-455 / CE-425: No special adjustment is needed.
3.
Confirm the power supply requirement of machine, and plug in the machine
with right power source as noted on the index tag.
4.
Turn on the main power switch on the right side of machine and power switch
on control panel. Then its light will be on.
5.
Turn on the “Heating” button, then temperature meter will show practical
value and set value; set required temperature according to the dimension of packing
products and thickness of film etc., normally 150-170
℃
.