85
Figure 83
Figure 84
Step 10
Check for secure installation:
• Grip Carrier near blue Vehicle Lap Belt Guides and
pull Carrier side-to-side and front-to-back to check
for secure installation, as shown in
Figure 83
. The
Carrier should not move more than 1 in. (2.5 cm) at
the belt path. Do not push down on Carrier near the
child’s feet when checking for movement.
NOTE:
If vehicle belt does not stay tight or Carrier
cannot be securely installed, try a different vehicle
seating location or install car seat using Car Seat
Base. See “Installing/Removing Car Seat with Base”
on
page 51
.
Step 11
Verify that the blue Recline Reference Line on side of
seat is parallel with ground, as shown in
Figure 84
. If
not, go back to
Step 6
, adjust the recline of the Carrier,
and install again – being careful during
Step 9
to push
the Carrier straight into the back of the vehicle seat
without tilting it more upright, or move the Carrier to a
different vehicle seating position.
NOTE:
If needed, a rolled towel or pool noodle may be
placed under the foot end of the Carrier to achieve an
acceptable recline level.
