8
P2349HW | 2019-08
Apex Tool Group
1
EN
Use the tool at the designated grip points.
Use the recommended reaction devices. For torques,
reference appropriate tool instruction manual.
After powering the controller on, wait until the boot
cycle is completed, approximately 60 seconds, before
powering it down again.
Use of Secondary controllers
Up to 15 Secondary Controllers can be added to a Primary
Controller (mPro400GCD-P). Upon shutting off or in case
of a Secondary Controller failure, the TSNet bus communi-
cation is interrupted. The communication loss to the Pri-
mary Controller has consequences for a Secondary
Controller:
→ No results are returned to the Primary Controller.
→ Additional rundowns are not initiated.
→ An in-process rundown is reported with the error
message SA (abort by removing the start signal) if
the TSNet connection is interrupted during tighten-
ing.
→ A shut-off signal is no longer received and so a
shut-off is only possible
-
via the start button of the tool
-
after reaching the shut-off criterion
-
via a safety shut-off after two seconds
WARNING!
During remote-start operation (multiple tool setup) an inter-
ruption of TSNet bus leads to a delayed stop of the spindle/
tool. This delay is 2 seconds.
Maintenance
The controller is generally maintenance-free.
Consider local regulations for maintenance and servic-
ing for all operating phases of the tightening system.
Cleaning
Only clean the exterior of the tool using a dry or slightly
damp cloth.
Do not immerse the controller or tools in any liquids.
Do not use a high pressure or abrasive cleaner.
Repair
Repairs to the equipment are not permitted.
Send the controller to a Authorized
Cleco Production Tools
Sales & Service Centers
.
Disposal
Components of the tightening system may present poten-
tial risks the environment. The tightening system contains
components that can be recycled, as well as components
that have specific disposal requirements.
Follow local applicable regulations.
First separate, then dispose of components.
Collect auxiliary materials (oils, greases) and dispose
properly.
Separate the components of the packaging and dis-
pose of them according to local regulations.
Return defective equipment to an approved collection
point or return it to the
Sales & Service Centers
.
Observe local regulations for disposal of
electronics and batteries. (In Germany,
the Electrical and Electronic Equipment
Act (ElektroG) and the Battery Act
(BattG)):
Used up batteries must be disposed
of properly. Return depleted or defec-
tive batteries to an approved collec-
tion facility or to
Sales & Service
Centers
for recycling.