CleaverBrooks ProFire Q Series, Установка, эксплуатация и обслуживание

Страница: 44 / 88

Operation
3-16
750-437
Q Series Full Modulation
{400: SEt} “400” flashing
press ( enter ) display shows:
{run}
press ( enter ) display shows:
{PH 12} = stand by
Turn the burner switch ON, and the burner progresses through pre-ignition phases and trial for flame:
{Ph22} = Fan motor on
{Ph24} = Traveling to pre-purge position
{Ph30} = Pre-purge countdown timer (30 sec)
{Ph36} = Traveling to ignition position
{Ph38} = Pre ignition Time
Progression stops at P0 setting: {P0: : GG.r} with "P0" blinking.
Press (+) to continue light off sequence:
{Ph40} = 1st Safety Time (ignition transformer ON)
{Ph42} = 1st Safety Time (ignition transformer OFF)
{Ph44} = Interval 1
If light off fails return and repeat from step d .
If light off is successful, the controller halts the sequence and displays:
{P0: : GG.G} “P0” is blinking
P0 may be adjusted further if desired. When satisfied with the P0 setting, press (+) to advance to P1.
G) Adjusting P1 through P9 points.
{P1: : GG.G} “ P1 ” is blinking
Using the combustion analyzer, verify combustion for low-fire P1.
If adjustment is needed,
AIR- Press and hold (VSD / F & A) and the display shows:
{1n: : SS.S} with “SS.S” value flashing
Use (+) or (-) to adjust the setting. When the intended value is reached, release the keys.
GAS- Press and hold (A) and the display shows:
{1A: : GG.G} with “GG.G” value flashing
Use (+) or (-) to adjust the setting. When the intended value is reached, release the keys.