Clearwater Spas Beachcraft Series, Руководство пользователя

Страница: 11 / 60

11
4. ELECTRICAL HOOK-UP
REQUIREMENTS - 240V
Removing spa panels
1. Remove the plastic
‘tap-cap’ decorative
screw head covers
from screws on spa
access panel.
2. Unscrew the
screws from the spa
access panel.
3. Remove the spa panel
for access to spa com-
ponents. Reverse these
steps to attach the spa
panel.
The closer you
locate the spa
to the main
service panel,
the less money
you will have to
spend on wire.
Wire can become
expensive if you
run long lengths.
Electrical Systems wired by Licensed Professionals
To ensure you will have an opportunity to use your spa soon after
delivery, it is very important that the required electrical service has
been installed properly by a professional, licensed electrician.
IMPORTANT: Electrical connections must be made by a
qualified, licensed professional. Please contact a licensed
residential electrician for these services.
Wiring Checks and Precautions
Safety is key when servicing any spa or spa control panel. Remember, safety
comes first for you and your customer. Please take all necessary precautions
before attempting any repairs. Wiring checks are the first step to ensure safety
and proper function before beginning service on a unit.
Always shut off
power at the
source when
working with any
electrical power!!
Failure to do this
could result in
serious injury or
even death!
• When working in a system box always be aware that it may
contain high voltage.
• Always keep your fingers and hand tools away from any wiring
or circuit board when the power is on. Touching anything in
these areas can result in serious injury.
• All service calls, no matter how minor, should include a
complete wiring check, beginning with the house breaker.
• Keep in mind, Balboa equipped spas only run on single phase
electrical service. Three phase power will not supply proper
voltage to the system. Three phase power may overheat the
pumps and cause the Residual Current Device (R.C.D.) to trip.
Check for Loose Connections or Damaged Wires:
• Make sure the power is off before you touch any wiring.
• Once the power is off, carefully examine all wires for cuts or defects.