CLEARSPAN
™
SUPER MOO-TEL
28
Revision date: 03.16.12
8. Slide the Twist-of-the-Wrist mounting plate over the
long bolts and secure the plate with two lock nuts.
9. Attach the Twist-of-the-Wrist gearbox to the mounting
plate using hex head bolts.
10. Using a 5/16" machine bolt and 5/16" nut, attach the
square shaft to a tubing adapter. (Carriage bolt is
shown for illustration. Use an FAG336B machine bolt.)
11. Slide the square shaft through the Twist-of-the-Wrist
gearbox.
Lock Nuts
12. Slide the Twist-of-the-Wrist assembly onto the
aluminum channel from the ground end. (This is the
free end of the channel.)
13. Adjust the roll-up cover conduit so that it reaches the
gearbox and
secure the cover to the conduit
using half
of the CC6212 fabric clips and Tek screws.
14. Roll the conduit toward the frame and up to the
gearbox to wrap the excess cover onto the conduit.
15. Attach the rolled conduit to the square shaft of the
assembly by inserting a 5/16" x 2-1/2" bolt through the
hole in the conduit and tubing adapter. Tighten the nut.
NOTE:
It may be necessary to trim the conduit and
cover to the proper length so that it aligns with the
gearbox. Adapt these instructions to your application.
16. Attach the crank handle to the Twist-of-the-Wrist
assembly. (Cover is not shown in the above diagram.)
17. Test the operation of the Twist-of-the-Wrist assembly.
NOTE:
If the cover rolls in the desired direction, but
you want to turn the crank in the opposite direction for
the same result, unbolt, reposition the gearbox, and
remount it on the same side of the mounting bracket.
Roll-Up Cover
Conduit
(Cover is not
shown.)
Fabric Clips
Install an FAG336B
bolt here
Frame differs from
actual frame.
TWIST-OF-THE-WRIST ASSEMBLY (CONTINUED)
