10
Revision date: 09.30.10
END
FRAME
DIMENSIONS
- 2
0'
WIDE
72"
96"
48
"
45 1/2"
6"
24 1/2"
GROUND LEVEL
72"
ATTENTION:
All dimensions are on-center
.
Cutting the V
ertical Supports to Length
This end frame kit is equipped with 2.375 pipe for the vertical supports. In some instances, these pipes are connected and cut to the required length.
Cut
only the plain end of the assembled pipe.
The tapered or swaged end of the vertical support is positioned at the top of the support. It is designed to fit into the underside of the roll-form rafter where it is secured using the fasteners. WHEN CUTTING PIPES
TO LENGTH, DO NOT
REMOVE
THE SW
AGED END OF
ANY
VER
TICAL
SUPPOR
T PIPE.
ATTENTION:
Use two sections of hat
channel to create the two upper end wall braces. Cut to length and overlap as needed.
Use two (2) sections of hat channel f
or
each
of the lower
two end wall braces. Overlap as needed.
