ClearSpan 106786, Руководство пользователя

Страница: 15 / 37

15
Revision date: 02.07.12
CLEARSPAN
™
POLY BUILDINGS
3. Collect the components needed for one cable assembly
and assemble as needed using the Cable - Details
diagrams for reference.
ATTENTION:
Cables are connected to the frame in
different ways in the different locations. Be sure that
you are looking at the correct diagram for the location
that you have prepared the cable assembly.
4. After the assembly is complete, attach it to the frame
in the location for which it was created. Verify that the
turnbuckle is in the open position before the assembly
is secured to the frame.
Refer to the notes at the
beginning of this section for additional information.
IMPORTANT: To prevent damage to the cover when
it is installed, do not wrap a cable around the outer
(or curved) tube of a rafter. Cable assembly ends are
either wrapped around the rafter and lateral brace
connection point, or are connected to anchor shackles.
5. Determine whether the assembly that was created
is the correct length and that cable is not too long
to cause cable waste. Adjust the dimensions of the
individual cable sections if needed.
DO NOT FULLY TIGHTEN THE CABLE ASSEMBLY AT
THIS TIME.
6. Repeat these steps to create identical assemblies for
the remaining identical locations and attach them to the
frame in those locations.
ATTENTION: Verify that the locations on the frame are
identical before you precut cable for the assemblies.
7. Choose another cable location, measure the required
cable assembly length and repeat the above steps as
needed.
8. After all cable assemblies are installed and snug, return
to each and tighten the turnbuckles.
ATTENTION:
The frame must be anchored to the site
before the cables are tightened.
9. After all cables are tight, continue with the final
inspection of the frame and then install the main cover.
INSTALL CABLES (CONTINUED)
FINAL FRAME CHECK
Before installing the main cover, check the following areas
of the frame to prevent cover damage and wear.
Required tools and parts:
• Duct tape and tools to tighten fasteners
• Lift or ladders to work safely at the height of the frame
• Head and eye protection
Complete these steps for a final frame inspection:
1. Verify that all fasteners used to secure the braces to
the frame are tight.
2. Recheck the frame assembly for sharp edges or
fasteners that may interfere with the installation of the
cover.
3. Use the supplied duct tape to tape any areas of the
frame that may damage the cover.
4. To prevent injury or damage to the main cover, secure
any loose cable end around the main cable using duct
tape.
5. Continue by wrapping vinyl stripping around the tube
splices of each end rafters.
ATTACH VINYL PROTECTIVE STRIP
The vinyl protective strip included with the building is used
at each end rafter to protect the cover when it is installed.
Required parts and tools:
• Vinyl strip (XR3705)
• Tek screws and 100441 nut setter
• Power driver to install Tek screws
Complete these steps to attach the vinyl stripping:
1. Cut a 10" - 12" piece of XR3705 vinyl from the roll.
2. Wrap the piece around one of the tube splices
identified by a circle in the diagram below.
Circles identify the tube splice locations that are wrapped
with the vinyl protective strip (XR3705).
End Rafter Diagram