9
CLEARSPAN™ SCREEN HOUSE
Revision date: 12.19.07
INSTALL END WALL FRAME ASSEMBLY: FRONT
The front end wall framing includes a base rail that is
attached between the end rafter legs at ground level. Below
describes one way to install the end wall.
Complete these steps to assemble the end wall framing for
the front end wall.
Required parts:
• 2" x 2" square tubes (#105328) (4)
• 1.75" x 1.75" square tube plain (#104075) (3)
• 36" x 80" door (#104706)
• Angle brackets (#QH1330) (6)
• 1.315" band clamps (#QH1400) (2)
• Square-to-Round brackets (#104074) (2)
• Tek screws (#FA4482B)
• 5/16" x 2 1/2" carriage bolts (#FAH320B)
• 5/16" nuts (#FALB02B)
ATTENTION
: Consult the End Framing - Connections in
the Quick Start Guide at the back of these instructions
before you start the steps that follow.
1. Locate two (2) 96" square tubes (#105328) and one (1)
16" square tube (#104075).
2. Measure and cut a 46" section of tube from one (1) of
the 96" square tubes.
3. Using the 16" square tube (#104075) as an insert,
connect the 46" and 96" square tubes to form the base
rail for the front end wall.
4. Rotate the square tube so that the Tek screws are to
the inside of the shelter.
ATTENTION:
To prevent damage to the end panel and
interference with the door installation, do not position
the rail with the Tek screw heads to the top or front/
outside surface of the assembled tube.
5. Attach one (1) angled bracket (#QH1330) to each end
of the base rail.
96''
Square Tube
46''
Square Tube
#104075
1.75" x 1.75" Square Tube (16'')
Tek Screws
NOTE:
Make sure the brackets are flush at each end of
the base rail.
6. Position the assembly between the legs of the front end
rafter and attach using Tek screws.
