ClearSpan 105680, Руководство пользователя

Страница: 20 / 33

CLEARSPAN™ SCREEN HOUSE
20
Revision date: 12.19.07
MAIN COVER INSTALLATION
The main cover is secured to the frame using ratchets and
straps. The straps are wrapped around a conduit inserted
in a pocket along each side of the cover.
When installed properly, the main cover skirt covers the
ratchets and straps used to secure the cover in place.
WARNING: To prevent damage to the cover and to
prevent serious personal injury,
DO NOT attempt to
install the main cover on windy days
.
The following steps describe one way to assemble the
cover conduits and to install the main cover.
1. Locate the round 1.315" pipes for the cover conduits
and assemble the two (2) cover conduits for the main
cover.
Each cover conduit assembly consist of following
swaged and plain pipes:
These cover conduits are inserted into the pockets
sewn into the main cover. The conduits are used to
tighten and secure the main cover.
3. Locate the main cover and spread it out on the ground
(with its underside facing up) along the side of the
assembled and anchored frame. See diagram below.
6. With all ropes attached to the cover conduit, lift the
conduit and carry the cover toward the base of the
frame.
7. Toss the ropes over the frame and pull the cover into
position. One person is required at each rope.
NOTE: Do not use the straps in the bonnet pocket
of the main cover to pull the cover into place.
These
straps will pull out.
8. With the cover on the frame, center the cover end-to-
end and side-to-side as needed.
Ropes
NOTE: The black straps in the main cover are
positioned at the front and back of the assembled
frame.
4. Insert the cover conduits into the pockets along the
sides of the main cover.
5. After inserting the cover conduits and with the cover
positioned along the side of the frame, attach ropes to
both ends of the cover conduit. Wrap the rope around
the conduit a few times to prevent it from slipping off.
Frame length shown may differ from actual frame.
Swaged Pipe Plain Pipe
105680 #131S075 (1) #131P0735 (1)
105681 #131S075 (2) #131P0735 (1)
105682 #131S075 (3) #131P0735 (1)
2. After assembling the two (2) cover conduits of equal
length, secure the pipe joints with a Tek screw and tape
over the screw head with duct tape.
Frame length shown may differ from actual frame.
Cover Conduits