15
CLEARSPAN™ SCREEN HOUSE
Revision date: 12.19.07
7. Fold the edges around the rafter pipes and secure
the panel to the rafter pipes using fabric clips and Tek
screws.
END PANEL INSTALLATION: FRONT (CONTINUED)
ATTENTION:
Divide the fabric clips in half and use half
to secure each end panel.
Space the clips evenly along
the rafter as shown above.
Position the Tek screws so they will not touch the main
cover when it is installed.
The number of fabric clips shown above may not match
the number used for your greenhouse.
8. After securing the end panel to the rafter, retighten the
frame anchors and cut the opening for the pedestrian
door.
View shows the inside
surface of the end panel.
Fabric clip
and Tek screw
CUT THE DOOR OPENING: FRONT END PANEL
The end panel material is cut and removed from the rough
opening of the pedestrian door. These steps describe one
way to do this.
1. From the outside of the shelter, use a utility knife to cut
the end panel as shown below. The dashed lines show
where to make the three (3) cuts.
2. After cutting the end panel in the locations shown by
the dashed lines, remove the part of the panel shown
by the shaded area in the diagram below.
ATTENTION:
Allow an 8" border to remain in the door
opening. The white areas in the above diagram identify
this 8" border.
This material is wrapped around the door frame tubes
of the end wall and secured to the inside of the door
frame tubes using Tek screws and fender washers.
3. Remove the end panel material
from the base rail
between the vertical door frame tubes
. See diagram
above.
4. Continue by installing the pedestrian door.
8" Border
(White area)
Remove
dark gray
area.
Cut on
dotted lines.
Remove end panel material.
