ClearOne Beamforming Microphone Array, Руководство по установке

Страница: 6 / 32

2 Beamforming Microphone Array
»
NOTE: The PoE connection is only for power, not control. Power must be supplied to
individual units; no daisy-chain power is allowed.
CONNECTIONS
The following section illustrates the connections made in a sample Beamforming Microphone Array
installation on a site.
p
owering the
B
eamforming
m
icrophone
a
rray
Powering the Beamforming Microphone Array can be through a standard Power-over-Ethernet
(PoE) switch or through an external PoE power supply. Use the appropriate AC cord to connect the
PoE power supply to the AC power. Then plug the PoE cable into the LAN+DC connection on the
power supply. Route the PoE cable where it can be fed through the ceiling mount assembly, wall
mount or to the conference table with the Beamforming Microphone Array. The following illustration
shows the cable connections with the PoE Power Supply.
Power Over Ethernet (PoE) Power Supply
(Front and Back Views)
Power Cord
to AC Power
PoE Ethernet Cable to
Beamforming Microphone Array
e-
Bus
c
onnections
The Beamforming Microphone Array units are connected to the CONVERGE Pro stack via the LINK
IN and LINK OUT E-bus connections using CAT5E RJ45 cables.
» NOTE: Firmware upgrades and Beamforming Microphone Array operation are
performed via the E-bus connection. Plugging the PoE cable into the E-bus
connections may cause damage to the Beamforming Microphone Array.