22)
The Drip seal is supplied in a 1m length, this will need to be
cut to the desired lengths for each side of the pivot . The
opening side Drip seal will also need to be notched to fit
under the door magnet profile. Make the Notch 13mm in
length and finishing down to the horizontal ledge of the
drip seal
Notch under Door Magnet profile
24)
For White Showers only - take the Cleaning
Towele e and wipe the surfaces of the
Powder coated profiles where Silicone will be
applied Allow to dry (1-2 minutes)
Sealing the Shower
26)
Cover Trim– (selected models only)
The Cover Trim is provided to cover the exposed
ver cal edge of the wall liner and is the final step
of the installa on. For some installa ons the Cover
trims may require cu ng to length
To fit the Cover trim apply small ver cal beads of silicone down
the Wall Receiver and the exposed wall lining outside of the Wall
Receiver. Embed the Cover trim into the silicone. If the
25)
The Door and Returns can now be sealed in
place using silicone sealant. Ensure all surfac-
es are first cleaned with dry clean cloth. Seal
between the tray upstand and the door set
along the bo om outside edges. Seal ver -
cally between the Wall Receivers and Wall
Liner
Note MASKING the area to be Sealed will result
in a superior finish
27) Your Shower is now complete. Allow a
Sealants to cure for a minimum of 24 hrs
IMPORTANT: DO NOT apply sealant to the inside of the shower
Drip Seals
23)
Fit the Drip Seals to the glass door
