21)
Slide the outside Clamp Block Covers off the
Pivot Clamp. Using a flat blade screwdriver
sufficiently loosen the two screws, adjust the
door by sliding le or right in the pivot
Once the door adjustment is complete ensure
the screws are re ghtened and reinstall the
Clamp Block Covers. Open the door and re-
move the door se ng block
18)
Using a 3.0mm drill bit, drill through the Wall Receiver sec ons and into the Return frames. (Use the “V”
groove line as a guide). Secure the Door set together using the No.6x10 Screws. Cover the screw heads
with the Cover caps
20)
Posi on le and right hand corner brackets over
the Corner posts
Using the No.6 x 10 screws secure the brackets into
the screw ports of the Corner Post. For the remain-
ing holes drill through the bracket holes into the
Door profile (3.0 mm drill bit) and fix in place using
No.6 x 10mm screws
No Cover caps are required for these screws
19)
Repeat for the Corner posts into the Door frame
Secure the Door Set (All Screw fixings are made from the Inside)
Adjust the Door
Brace Brackets
