Clear-Com ICS-2003, Инструкция по эксплуатации

Страница: 14 / 69

I C S - 2 0 0 3 I N T E R C O M S T A T I O N
1 - 8
Listen-Level Mode
To use the listen-level adjust mode:
1. Push (for less than 1 second) and quickly release the “Listen Level” button.
2. “Listen Level Adjust Mode” will appear in the message window to indicate the
function is on and the LEDs of all active listen selectors will begin to flash.
Note: Only active selectors can be adjusted in listen-level mode.
3. Use the selector associated with the intended label to increase (up) or decrease
(down) the volume.
4. To exit, push the “Listen Level” button or wait for the 3 second time-out.
Listen Level Reset
To reset the Listen Level to default settings:
1. Press (for less than 1 second) and quickly release the “Listen Level” button.
2. Press and hold the “Listen Level” button for 3 seconds.
3. Release the “Listen Level” button.
Call Signals
To activate a call signal push and hold (for at least 1 second) the “Listen Level”
button until the station indicates it is in “Call Signal” mode.
The call signal will be sent each time the selector with that label assignment is
pushed down and will remain so until the call-signal mode times out (about 5
seconds).
Call signals can be issued to any talk label assigned to a station’s talk/listen
selectors. If more than one label is assigned to a selector, all labels will receive the
signal. If a label is a fixed group, the entire group will receive the call signal. If the
label is a party line, then every station listening on the party line will receive the
call signal.
Remote Telephone Line Release
This function is available only if specifically enabled in the configuration
program. To hang up a telephone interface left off the hook:
1. Push and hold the “Listen Level” button for at least 1 second to activate the
call-signal mode.
2. While holding the “Listen Level” button, press the talk selector of the desired
telephone’s label.
3. Release the “Listen Level” button.
Note: In addition to hanging up the telephone interface, this will deactivate any
talk/listen selector set to the interface from anywhere in the system.