CleanCraft HDR-H 108-20, Инструкция по эксплуатации и техническому обслуживанию

Страница: 26 / 102

PROBLEM CAUSE SOLUTION
Wa t er leak ing fr om
under the high pressure
cleaner. Safety valve triggered.
IF THIS HAPPENS PERSISTENTLY DO NOT USE
THE HIGH PRESSURE CLEANER BUT CONTACT A
QUALIFIED TECHNICIAN.
T h e c l e a n e r s t o p s
w or k ing a n d t h e
warning light (42) is off.
A safety device has been
tripped in the system where
the cleaner is connected (a
fuse, differential switch,
etc.). Reset the safety device.
SHOULD IT TRIP
AGAIN , DO NOT USE THE CLEANER AND
CONTACT A QUALIFIED TECHNICIAN.
T h e c l e a n e r s t o p s
wo r k i n g a n d t h e
warning light (42) is on.
(warning light (46)) is on. The amperometric protector
has tripped. Follow the instructions in
“SAFETY FEATURES”.
T h e c l e a n e r r
e s u m e s o p e r a t i o n
spontaneously when it is
in Total Stop mode. L eaks and/or dr ips in
the delivery
circuit.
Inspect the delivery circuit for leaks.
When the master switch
(1) is tur ned on, the
engine hums but does not
start up. Unsuitable electrical
system and/or extension
lead Check the instructions for connecting up to
the mains power supply have been followed
correctly (refer to the
INSTRUCTIONS MANUAL
– SAFE T Y INSTR UC TIONS
), especially as
regards the use of an extension lead.
The cleaner does not
deliver hot water There is not enough fuel in
the tank (warning light 44
is lit). Top up with fuel.
The fuel filter is dirty. Follow the instructions in
“SUPPLEMENTARY
MAINTENANCE”.
The boiler’s safety
thermostat has tripped. Leave the cleaner to cool down for a few
minutes so the safety device can reset.
SHOULD IT TRIP AGAIN, DO NOT USE THE
C LE A NE R A N D C O N TA C T A QU A L I FI E D
TECHNICIAN
.
T h e b u r n e r c o n t r o l l e r
h a s tripped (warning light
49 is lit). Turn the master switch (1) to “0” , wait a few
seconds and then turn it to .
SHOULD IT TRIP AGAIN, DO NOT USE THE
C LE A NE R A N D C O N TA C T A QU A L I FI E D
TECHNICIAN
.
T he cleaner will not
start up again and the
warning light (45) is lit. The cleaner has been
inactive for
more than 15 minutes and
has entered Timed
Shutdown mode.
Follow the instructions in
“STOPPING THE
CLEANER/INTERRUPTING THE OPERATION –
TIMED SHUTDOWN”
T he cleaner will not
start up again and the
warning light (47) is lit. Leaks have been detected in
the deliver y circuit
causing the cleaner to
restart several times: the
relative safety device has
tripped causing the
cleaner to stop working. Turn the master switch (1) to “0” , wait for
a few seconds and star t up the cleaner
again.
SHOULD IT TRIP AGAIN, DO NOT USE
THE CLEANER AND CONTAC T A QUALIFIED
TECHNICIAN.
I n S t eam mode , the
burner does not start or
stops working and the
warning light (48) is lit . Pressure above 32 bar/464
psi. Follow the instructions in
“OPERATING THE
CLEANER IN STEAM MODE”
.
Lamp (49) flashing. M a l f u n c t i o n i n
s o m e temperature control
evice Use the machine only in Cold Water.
CONTACT A QUALIFIED TECHNICIAN.
26