CleanCraft 7520100, Руководство по эксплуатации

Страница: 12 / 26

12 Water Pumps | Version 1.02
Installation
Reset to clear water mode:
Step 1: Turn the electric pump so that the floor is facing
you.
Step 2: Turn the foot clockwise to activate.
Step 3:Push your feet inward and turn clockwise to the
end.
Fig. 12: Setting the dirty water mode
8 Installation
8.1 Notes on installation
Step 1: Submerge the pump at an angle to avoid an air
cushion at the bottom that would prevent it from
being sucked in.
Step 2: Put the pump in an upright position once im-
mersed.
Step 3: Lower the pump to the bottom of the liquid con-
tainer. If necessary, use a rope.
Step 4: Place the water pump at a certain height (espe-
cially in conditions of heavy soiling), so that the
inlet of the water pump is not blocked.
Step 5: If possible, make sure that the pump is com-
pletely under water.
Step 6: Make sure that the water pump is placed in a po-
sition where the float switch can move freely.
(space required for model SCWP 10013:
500mm x500mm)
Step 7: Make sure that there is sufficient stability to se-
cure the upright position.
All connection lines must be absolutely leak-tight, as
leaking lines can impair the performance of the pump
and cause considerable damage. It is therefore essen-
tial to seal the threaded parts of the cables with each
other and the connection to the pump with Teflon tape.
Only the use of sealing material such as Teflon tape en-
sures that the assembly is airtight.
Avoid excessive force when tightening fittings, which
can cause damage.
When laying the connecting cables, make sure that no
weight, vibrations or tensions are applied to the pump.
In addition, the connecting cables must not be dam-
aged or have a counterfall to the pump.
8.2 Electrical connection
The device has a power cord with mains plug:
- Power supply cables and power plugs may only
be replaced by qualified personnel in order to
avoid hazards.
- Never lift or carry the pump by the power cable!
- Never unplug the power cord by pulling on the
cord from the socket. Always pull on the power
plug.
ATTENTION!
When installing the unit, make sure that the motor is
adequately ventilated.
ATTENTION!
The pump must not be immersed deeper in the
water than specified in the "Technical data" (see
suction height).
Baseplate
Base
board
Foot
Pump works in clear water mode
Basis-
platte
Baseplate
Base
board
Foot
The foot is in the activated mode
Pump works in dirty water mode
Base-
plate
Base
board
Foot
ATTENTION!
The pump must never be drained by the power cord
or the water drain hose!
Always use a sufficiently strong rope.