CleanCraft 7520100, Руководство по эксплуатации

Страница: 11 / 26

Device description
Water Pumps | Version 1.02 11
On the side of the pump is a cable groove (Fig.8 Pos.3).
The power supply cable of the float switch can be ad-
justed to the required length by hooking it into the cable
groove. Make sure that the float switch can swing freely
after adjusting the supply cable length.
Effects of the cable insertion point:
- Float switch on a short cable end: The positions
ON and OFF are close to each other.
- Float switch on a long cable end: The ON and OFF
positions are far apart.
Positioning
Move the electric pump only by the carrying handle. The
pump can also be lifted with a rope and positioned in a
small space. The rope must be attached to the carrying
handle.
Fig. 9: Correct lifting or mounting of a rope SCWP 7514
Fig. 10: Correct lifting or mounting of a rope SDWP 10020
Fig. 11: Correct lifting or mounting of a rope SPWP 1107
On certain models, there is an outlet on the contact sur-
face between the pump body and the head cover. It is a
normal phenomenon for an electric pump that it re-
leases a little water from the hole during normal opera-
tion.
Adjustment of the combo function on the model SDWP 7514:
In the combination version, the foot position can be ad-
justed to change the working status of the pump.
Change of water mode from clear to dirty water:
Step 1: Turn the electric pump so that the floor is facing
you (Fig.12).
Step 2: Turn the foot counter-clockwise to activate it.
Step 3: Pull out the foot and turn it counter-clockwise to
the end.
ATTENTION!
Make sure that the water chamber of the pump is
always filled with water before starting the pump.
Dry running can damage the pump.
ATTENTION!
In the event of malicious damage or alteration, the
manufacturer can not verify that the electric pump is
working normally.
ATTENTION!
The water quality may change due to the non-toxic
oil in the sealing device.