8
2.3 Pin Set Installation
NOTE: AIR SUPPLY MUST BE DISCONNECTED AND THE JAWS MUST BE IN
THE CLOSED POSTION.
Remove the magazine from the unit by pulling straight up. Loosen the six button head
screws on both sides of the cover. Lift the cover up and carefully place on left side of
base as wire and air lines are connected from the cover to the unit.
The CRD610 is equipped with a Pin Set Assembly which is designed for a specific tube
fitting.
Before installing the pin set, roll the pin on a flat surface to insure that it is straight.
Insert the pin tip into the hole near the bottom of the magazine rack. Slide the pin
through the hole until it is horizontal within the CRD610.
Figure 2.4.6
Push the pin toward the back of the unit until the threaded end reaches the threaded
cylinder rod. Turn the pin clockwise to tighten.
Once the pin is hand-tightened, pull the pin forward exposing the cylinder.
Figure 2.4.7
Place a 1/2” open end wrench on the flats of the cylinder rod and hold in place.
Place a 5/8” open end wrench onto the flats of the pin set and tighten pin set into the
cylinder rod.
Figure 2.4.8
Manually pull the pin forward to ensure it goes through the magazine and into the jaw
set.
