CLEAN BURN CB-3500 series, Руководство оператора

Страница: 50 / 134

Operator's Manual: Models CB-3500 & CB-5000
4-14
Installing the Suction Oil Line Components (continued)
(1.) (e.) Prepare the canister filter for installation
(continued):
• Install this assembly into one side of the 1/2" brass tee.
• Install the assembled 1/2" tee into the 3/4" x 1/2" brass bushing, which is installed in
the inlet port of the canister filter. Make sure that the 1/2" flare adapter is pointing down.
• Install the canister filter assembly onto the 1/4" brass street elbow as shown in Figure 4H.
The canister filter must be installed with the arrow pointing towards the pump (direction of
oil flow).
• Install the 1/2" x 5" brass nipple into the top side of the 1/2" brass tee assembly.
• Loosely install the 1/2" brass cap onto this nipple; DO NOT tighten the cap at this time.
Figure 4J - Oil Line Installation Overview
OF COPPER TUBING
TO CREATE SLUDGE TRAP
12 IN. OFF TANK BOTTOM
CHECK VALVE IS MINIMUM
INSIDE TANK:
CONTINUOUS PIECE
TO HOLD TUBING
INSTALL SLIP FITTING
IN PLACE
I88807-E
COMPRESSED AIR LINE
NO
T PRIME AND/OR
THE FL
OW R
ATE FR
OM
VER
TIC
AL SUC
TION LIFT OR
THE PUMP
WILL
CA
UTION: DO NO
T EX
CEED 6 FT (183 cm)
THE PUMP M
AY DECREASE
BALL VALVE
M
AXIMUM 6 FT (183 cm)
1/2" O.D.
OIL FL
OW
CHECK VALVE SCREEN
SUCTION LINE
IN SUCTION LINE
CANISTER FILTER
PRESSURE OIL LINE
OIL PUMP ELEC
TRIC
AL CIR
CUIT
WITH BALL VALVE
VENT RELIEF
CLEAN-OUT
FUNNEL
EMERGENCY
VENT
CAP
WEIGHT TURN
FOR MORE DRAFT
AIR OIL