15
GLOW UP
Initial projector address settings
An initial address must be set on each single project for the control signal.
Address settings: see page 16.
DMX Address
ADDR 001
BAT 40%
STND
Yy
FRES/W
Time or percent remaining
of the battery charge
Operating mode
(see page 23)
Link status
(Wireless or Wired)
Factory reset? Y/N
Warning Radio
W42 (radio board not found)
W43 (radio board not interact)
If errors W42/W43 appear on the display, do
an RDM Discovery (see page 16) to see if the
error disappears. If it does not, check the
intactness of the wireless board.
Button functions – Menu SET
• If pressed in idle status:
Cyclically switches between idle status and menu settings.
• If pressed while setting a menu:
Moves to an upper level without changing anything (exits the function)
Decreases the value displayed (with auto-repetitions), or passes to the next item on the menu
For quick access to the minimum parameter value, press the UP key while holding down the DOWN key.
Increases the value displayed (with auto-repetitions), or passes to the previous item on the menu
For quick access to the maximum parameter value, press the DOWN key while holding down the UP key.
Confirms the displayed value or activates the displayed function or opens the next menu.
SELECT
DOWN
UP
ENTER
When GlowUp is in idle status the information page will appear on the display:
Transmission to DMX cable
Reception from DMX cable
Reception DMX from Radio (wireless)
Transmission DMX from Radio (wireless)
Display symbology - (Link Status)
