SET ……….
ADVANCED
To enable the "Menu Advanced" enter the code (1234) using the UP, DOWN and ENTER keys.
SET - ADVANCED – SETUP ……….
RADIO
It assigns the desired command to the GLOW UP 'Radio' module choosing from one of the following:
•
Unlink Transmitter:
Disconnected from the transmitter
•
Link Receivers:
Connected to all free receivers
•
Unlink Receiver:
Disconnected from all receivers
•
Tx mode:
It allows the user to select one of the two available transmission channels between G3
(recommended for those who do not use RDM-wireless commands) and G4 (only recommended if RDM-
wireless commands are used).
RDM discovery
– to be used only when the wireless card is replaced; press ENTER to start the automatic
search option.
SET - ADVANCED – SETUP ……….
MODE
It allows the GlowUp operating mode to be assigned:
SLAVE PRIORITY
: GlowUp operates as Slave, press ENTER to select the DMX signal reception priority in the
event of conflict between cable or wireless signal.
•
Cable
(default)
•
Wireless
MASTER OUTPUT
: GlowUp operates as Master, press ENTER and use the UP and DOWN keys to select
how the DMX signal is transmitted to other devices:
•
Cable+Wireless
•
Cable
•
Wireless
REPEATER
: GlowUp runs as a repeater.
In this case, select how GlowUP runs as a repeater meaning:
Direction:
select whether the repeater should send the DMX signal from:
•
Wireless to Cable
•
Cable to Wireless
Function:
select whether the repeater should run from:
•
Repeat & Play
(GlowUp repeats and plays)
•
Repeat Only
(GlowUp only runs as repeater)
To enable the REPEATER function, turn on (Enable) or off (Disable)
22
GLOW UP
