12
41000664 Iss 05
It is recommended that the chassis is removed
from the back box to avoid having to support the
weight of the product during installation.
To separate the chassis from the back box undo
and remove the nuts shown and lift the chassis
away from the back box.
The product can be installed using either M12
drop rods or fastened direct to the wall using
appropriate sized fixings suitable for the wall
surface and the weight of the product.
Step 4
To wall mount the product, position the back box
against the wall at the desired mounting height
and mark through the holes in the back box
brackets to enable the wall to be drilled for the
appropriate fixings.
Step 5
Drill the wall then fix the backbox in position. Lift
the chassis (using lifting gear if necessary) onto
the studs on the back box brackets. Refit and
tighten the nuts.
Step 6
Holes are provided in the back box for the feed
cable to enter the case. Choose the appropriate
hole top rear to suit the installation.
Fit suitable cable gland for size of cable.
Step 7
To install the product using M12 drop rods follow
instructions from step 4. If the decorative tube is to
be used, fit this over the drop rod, then pass the
drop rod through the back box brackets.
Step 8
