Classic AutoAir 1971-1973 Mustang A/C system, Руководство по установке

Страница: 16 / 38

16
FIGURE 21
FIGURE 20
DASH
FIRE
W
ALL
1/4 - #20 x 5/8" bolts and
a 1/4” washer
Installing the complete evaporator unit under the dash will go much easier with
the help of a friend. One person can take the unit within the car and “roll” up
and under the dash while the other person can be ready at the firewall area with
one of the 1/4" - #20 x 5/8" bolts to secure the unit in place (see figure 20).
Now the unit will be easy to level and secure. Leveling the unit is very important
to insure proper drainage of condensation.
On back side of the evaporator is a mounting bracket with a 1/4"-20 J-clip. This
bracket will go flush with the inside firewall and you will secure the evaporator
by inserting one 1/4" - #20 x 5/8" bolt with a 1/4” washer (from the engine side)
using the bottom right hole (that originally attached the original heater assembly,
see figure 21).
Be sure to align the evaporator unit level with the bottom of instrument
panel (assuming the vehicle is sitting level) as shown above, but with a small
degree of tilt toward the back to allow proper drain of condensation.
TECH TIPS
LEVEL
www.classicautoair.com • 866.435.7801