Classeq C200G, Инструкция по установке и эксплуатации, Страница: 9 / 16

Page 7
5.3 Switch the machine on :
Ensure that both the water and electrical supply are connected and turned on, then
depress the ‘ON/OFF’ button located on the front of the machine.
The machine will now automatically fill and heat, during this process the door should remain closed,
allowing the process to be completed quickly.
5.4 Machine ready to operate :
As state section 4.3 of this manual, it will be possible to start a cycle prior to the ‘
Machine Green ’
lamp being illuminated, to ensure NSF compliance ‘Classeq’ recommends that you wait for the
lamp to be illuminated before requesting a cycle to commence.
Please note for safety reason the wash heating element turns off when the door is opened,
’ Classeq ’ therefore advise that the door is closed between cycles.
5.5 Starting a cycle :
To start a cycle, open the door / hood, depending upon your appliance, load the first
basket, ensuring that all arms rotate freely.
Close the door, then depress the ‘Cycle’ button, your appliance will now automatically progress
though the cycle, during which time the ‘Cycle’ lamp will be illuminated.
At the end of the cycle open the door and remove the basket, then reload the machine
and repeat as required
5.6 Draining :
During normal operation your appliance will automatically drain away any excess water. ’ Classeq ’
recommends if your appliance is not being used for a prolonged period of time the machine must be
completely drained down
C200G and C500U
•
Switch appliance OFF at the front
•
Remove drain plug from wash tank.
•
Ensure that door is closed
•
Your appliance will now automatically drain down
•
Once completed replace the drain plug.
•
Now isolate main water and electricity at the wall.
C300G, C750U and C850P
•
Switch appliance OFF at the front.
•
Ensure the door is closed.
•
Your appliance will now automatically drain down
•
Once completed, isolate main water and electricity at the wall.
Note !
Once empty ‘ Classeq ’ recommends that the main water and electricity supplies are
isolated at the wall and the machine be cleaned as instructed in section 6 of this manual
For hygiene reasons it is recommended that once the appliance has been drained that
the door is left open to assist in natural drying of the wash chamber