Page 9
7.0 Trouble shooting
7.0 Trouble shooting
•
Before placing a service call, please check the following:
•
Check the appliance is connected to the main water and electricity supply and both are turned
on.
•
Check levels of chemicals within the rinse aid and detergent bottles.
•
Check the drain / stand pipe is correct for the appliance (refer to section 3.3.2 of this manual).
NOTE
In the event of a service call being made under Warranty, and it is found that the faults are due
to non-observance of instructions in this manual, the call will be charged at current rates.
7.1 Appliance does not fill :
Appliance does not start :
Appliance does not rinse :
•
Check water supply is turned ON.
•
Check water supply hose is not trapped or kinked.
•
Check that the appliance is turned ON at the source.
•
Drain appliance fully, then try again to fill the machine, drain as per instructions 5.6 of this
manual..
7.2 Appliance fills slowly :
•
Check water supply valve is fully open.
•
Check water supply pressure, should be above 30 lbs per square inch, if not ask your dealer
to install a booster pump to increase water pressure.
•
Check and clean rinse jets (located on the wash arms within the appliance).
•
Check water supply hose is not trapped or kinked.
•
Remove any pressure regulator or reducer from the water supply.
7.3 Appliance not heating :
•
Drain appliance fully, then try again to fill the machine, drain as per instructions 5.6 of this
manual.
•
Check the temperature of the main water, as variations in water temperature will affect the
heating of the appliance.
•
Check that the wash chamber is full of water.
7.4 Appliance not draining :
•
Check and clean all filters within the appliance.
•
Check that the stand pipe / drain is not clogged / blocked.
