7
English
Unlock
Lock
Use
Chuck
1. The hammer drill has a keyless quick
chuck (1.5–13 mm).
2. Hold the rear collar of the chuck and
twist the front collar anticlockwise until
the jaws are wide enough apart to
allow the drill bit to enter.
3. Insert a drill bit or other tool.
4. Hold the rear collar of the chuck and
twist the front collar until the jaws lock
onto the tool or bit.
Note:
Do not try to tighten the chuck by holding the rear collar whilst starting the drill;
this could result in personal injury. Moreover, the chuck tightens better if the two collars
are gripped and tightened by hand.
Side handle
1. Twist the side handle as shown in
the picture to undo it.
2. Set the side handle to the desired
position, set the depth stop if required.
3. Twist the side handle as shown in
the picture to lock both the handle
and the depth stop.
Power switch
1. Plug the lead into a wall socket after
inserting a tool into the chuck and
tightening it.
2. Start the hammer drill by gently pulling
the power trigger (7), check that
the tool rotates in the correct direction.
Release the power trigger to stop
the drill.
3. When the chuck is rotating, the power
trigger can be locked by pressing
the lock button (8) and releasing
the power trigger.
4. To stop the drill, pull the power switch
and then release it.
