Clarke Woodworker CTS10D, Руководство по эксплуатации и техническому обслуживанию

Страница: 21 / 26

21
MAINTENANCE
WARNING!
FOR YOUR OWN SAFETY, SWITCH MACHINE OFF AND REMOVE PLUG FROM POWER SOURCE
BEFORE ADJUSTING, MAINTAINING OR LUBRICATING YOUR SAW.
Do not allow sawdust to accumulate inside the saw. Use a dust extractor if possible, if not,
frequently blow out any dust that may accumulate inside the saw cabinet and the motor.
Inspect the power cable frequently. If it is worn or cut, or damaged in any way, have it replaced
immediately.
NOTE: Certain cleaning agents and solvents can damage plastic parts. Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents, ammonia and household detergents which contain ammonia.
Avoiding the use of these and other types of cleaning agents will minimise the possibility of damage.
A coat of wax applied to the table will help to keep the surface clean and allow workpieces to
slide more freely.
1. Changing the Blade
IMPORTANT: 1. Use only Clarke Blade, (see parts list for part numbers).
2. Replace the blade when teeth become damaged or dull.
WARNING!
1. TO PREVENT PERSONAL INJURY, ALWAYS DISCONNECT PLUG FROM POWER SOURCE
BEFORE CHANGING BLADES.
2. TAKE GREAT CARE WHEN HANDLING SAW BLADES - THE TEETH ARE EXTREMELY SHARP,
AND CARELESSNESS CAN CAUSE SERIOUS PERSONAL INJURY
1. Raise the blade as far as possible,
then remove the blade Guard... a
single mounting bolt.
It also helps to turn the blade angle
adjuster so as to lay the blade on
its side to some degree.
NOTE: From this point, take great care to avoid
contact with the tips of the saw blade,
preferably place a thick cloth over the teeth,
as shown in Fig 21.
2. Undo the Blade securing nut, using
the two spanners provided, one to
engage with the flats on the outer
flange, the other to remove the nut.
3. Replace the blade in reverse order,
Fig.21
ensuring the teeth point down towards the table at the front, and it sits snugly on the boss
on the inner flange before replacing the outer flange and tightening the securing nut.