Clarke Woodworker CTS10D, Руководство по эксплуатации и техническому обслуживанию

Страница: 15 / 26

MOUNTING THE SAW
IMPORTANT
If the saw is to be a permanent fixture, ensure it is sited in an area with adequate
illumination and power supply.
DO NOT place it where you will be working in your own shadow, or where extension
cables are required - these are hazardous in a workshop environment.
If the table saw is to be used in a permanent location, it should be fastened securely to a firm
supporting surface such as a stand or workbench, using the four mounting holes in the base.
A Floor Stand, specially designed for your CTS10D Table Saw
is available from your CLARKE dealer .
Holes should be drilled through the supporting surface of the workbench, using the machine as
a template to mark out the holes.
If a VACUUM DUST EXTRACTION device is NOT to be used, an opening MUST also be made in the
workbench, the same size as the opening in the bottom of the saw. (which houses the Bottom Grille).
This is in order to allow the saw dust to drop through.
IMPORTANT
Ensure the Bottom Grille is in place when bolting the machine to the workbench.
1. Each of the four mounting holes should be bolted securely using 8mm bolts (not
included) which should be 12mm longer than the thickness of the bench top.
2. Locate and mark where the saw is to be mounted.
3. Drill four (4) 10mm diameter holes through workbench.
4. Place table saw on the workbench aligning the holes in the base with the holes drilled in
the workbench.
5. Bolt down ensuring flat and spring washers are used at the bolt head and with the nut.
Mounting to Plywood
An alternative method of securing your table saw is to fasten the saw base to a mounting
board, 600x600mm minimum size, to prevent the saw from tipping whilst in use. A good grade
of plywood with a minimum thickness of 19mm is recommended.
Follow the instructions for mounting to a workbench, substituting a plywood board with a minimum
size of 600x600mm.
The opening in the board should be the same as the bottom grille.
To secure the table saw to the plywood board use 8mm countersunk screws with lockwashers
and hex nuts (not included). Screw length must be at least 12mm more than the thickness of
the mounting board.
H. Push Stick Brackets
Screw on the Push Stick Spring Clips to the left side of the main casing, using the four screws,
and washers provided.
NOTE: For proper stability, holes must be counter sunk on the underside of the plywood so that screw
heads are flush with the bottom surface of the mounting board.
IMPORTANT
Ensure the Bottom Grille is in place when bolting the machine to the workbench.
15