20
6. Mitre Cutting
Mitre cutting is the term used for cutting at an angle
other than 90
O
to the edge of the wood. Follow the same
procedure as you would for crosscutting.
Adjust the mitre gauge to the desired angle, and lock it.
The mitre gauge may be used in either of the
grooves in the table.
When using the mitre gauge in the LEFT hand
groove, hold the workpiece firmly against the mitre
gauge head with your LEFT HAND, and grip the lock
knob with your right.
When using the RIGHT hand groove, hold the
workpiece with your RIGHT HAND and the lock knob
with your left hand.
8. Compound Mitre Cutting
Compound mitre cutting is a combination of mitre cutting and bevel crosscutting. The cut is
made at an angle other than 90
O
to both the edge and the flat side of the wood.
Adjust the mitre gauge and the blade to the desired angle, and ensure the mitre gauge body is locked.
WARNING!
WHEN MITRE CUTTING, AN AREA OF BLADE IS EXPOSED.
GREAT CARE MUST BE TAKEN WHEN USING THE MACHINE FOR THIS OPERATION.
7. Bevel Crosscutting
Bevel crosscutting is the same as crosscutting
except that the wood is also cut at an angle, other
than 90 degrees with the flat side of the wood.
Adjust the blade to the desired height and angle.
Use the Mitre Gauge in the groove to the RIGHT of
the blade. It cannot be used in the groove to the
LEFT because the blade guard will interfere. Hold
the workpiece with your right hand and the lock
knob with your left hand.
Fig.20
Fig.19
2.
Slide the workpiece along the mitre gauge until it touches the block, hold it securely.
When cutting long workpieces, make sure the end is supported - from the floor.
3.
Make the cut, pull the workpiece back and push the cut-off piece off the table with a
long push stick,
DO NOT ATTEMPT TO PICK IT UP AS THIS COULD ENDANGER YOUR HANDS
WARNING!
NEVER USE THE RIP FENCE AS A LENGTH STOP BECAUSE THE CUT-OFF PIECE COULD BIND
BETWEEN THE FENCE AND THE BLADE CAUSING A KICKBACK.
Содержание Woodworker CTS10D
Страница 2: ...2...
Страница 26: ...PARTS DIAGRAM 26...
