Clarke Woodworker CTS10D, Руководство по эксплуатации и техническому обслуживанию

Страница: 16 / 26

IMPORTANT CHECKS - BEFORE STARTING
IMPORTANT:
Before attempting to use the machine, it is necessary to ensure the various
components are correctly adjusted, and checked for security.
ALWAYS raise the blade and check for security.
Ensure the Blade Guard is fitted and is secure, capable of dropping under its own weight.
Remove all tools or pieces of wood from the table.
Ensure the Rip Fence is secure.
Ensure the saw Blade is at the desired height and locked in place.
16
OPERATION
1. Starting and Stopping the Machine
The ON and OFF switches are located on the front left of the machine.
The upper, GREEN switch is the ‘ON’ switch and is marked with an ‘I’ symbol.
The lower, RED switch is the ‘OFF’ switch. It is raised and marked with the symbol ‘O’.
For additional safety, the ON switch is a ‘NO VOLT RELEASE’ type. This means that if the power is
interrupted for whatever reason whilst the machine is switched ON, the no volt release will
automatically trip, setting the machine to the OFF position, thereby preventing it from starting
again when the power is restored. The machine may then be restarted by pressing the ON
switch.
OVERLOAD CUT-OUT
Your machine also features an OVERLOAD CUTOUT device, so that if the machine is overloaded
(due to feed pressure being too great, a dull blade or low voltage etc.), the overload relay will
intervene and the motor will automatically cut out. In this event:
a. Press the OFF button and disconnect from the mains supply.
b. Allow the motor to cool for three to five minutes.
b. Push the reset button, adjacent to the ON/OFF switches, which resets the overload
device.
c. Plug the machine back into the mains supply, and switch the saw back on.
WARNING!
THE MACHINE MUST BE IN THE OFF POSITION, AND THE PLUG REMOVED FROM THE POWER
SOURCE WHILST COOLING DOWN TAKES PLACE. THIS PREVENTS ACCIDENTAL STARTING WHEN
THE RESET BUTTON IS PUSHED, AS THE NO VOLT RELEASE WILL NOT HAVE TRIPPED .