Clarke Woodworker CTS10D, Руководство по эксплуатации и техническому обслуживанию

Страница: 13 / 26

3. Attach the Riving Knife to the bracket
as shown in Fig. 5, using the two hex.
socket head screws with spring and
flat washers provided.
Ensure the Clamping Bracket is correctly
oriented, as illustrated in Fig.6, and the
Riving knife is adjusted so that a clearance
of no more than 5mm exists between blade
and knife, and along the full length of the
riving knife, as illustrated in Fig. 7
✔
Clamping
Bracket
>
<
Riving
Knife
<
>
✘
✘
✘ ✔
Note:
It is most important that the Riving Knife is directly in line with the blade at all times. If at any
time it becomes misaligned, it must be straightened before the saw is put into use.
D. Riving Knife
1. Remove the Table Insert (8 countersunk head screws).
2. Raise the blade to its fullest extent....it is helpful also, to turn the angle adjuster so as to lay
the blade on its side to some degree
IMPORTANT:
Take great care to avoid contact with the saw teeth which are extremely sharp
when performing the following operations.
4. When satisfied, ensure all securing screws are tight before replacing the Table Insert.
Fig.5
Fig.7
Fig.6
13