Clarke Woodworker CPT600, Инструкция по эксплуатации и обслуживанию

Страница: 11 / 24

11
C. Reset Button
The table saw is fitted with an thermal
overload protector. If the motor stops
running or fails to start.
1. Close the safety switch cover and allow
the motor to cool for five minutes.
2. Press the reset button.
3. Raise the cover of the ON/OFF switch
and press the green ON button, marked
‘I’.
Always disconnect the machine from the mains supply before cleaning or
performing maintenance tasks.
This product is designed to operate with minimum of maintenance, however, as
with all power tools, cleanliness is essential in ensuring work is carried out to a
satisfactory standard. Always keep the table free of shavings/dust etc., and clean
the machine thoroughly after use. Use a low pressure air supply to blow dust from
air vents and other parts wherever possible.
Apply a thin film of wax to the table periodically. This will help keep the table
clean and allow the workpiece to slide more easily.
Do not use solvents to clean the machine as this could damage plastic
components.
Cutter Blade Removal
Cutter blades will require sharpening or replacing. Care should be taken at all
times when handling them, they are very sharp, even when appearing to be dull.
Blades must always be fitted as a pair, and must be of the same type, only fit blades
recommended by the Clarke International.
First, ensure the machine is switched OFF and isolated from the mains supply.
1. Turn the cutter height adjuster so that it registers zero. i.e. turn the knob
clockwise so that the depth of cut, registered on the scale, is zero.
1. Remove the Angle Fence.
2. Raise the Cutter Guard arm.
3. Turn the cutter block to reveal the four hex. socket head screws securing the
cutter blade, then carefully remove them.
4. Turn the cutter block by 180 degrees and repeat the process.
ALWAYS hone/replace cutter blades as a pair.
MAINTENANCE