Clarke Woodworker CPT600, Инструкция по эксплуатации и обслуживанию

Страница: 8 / 24

8
1. Attaching the Angle Fence
The peg - ‘A’ locates in the slotted
hole - ‘B’. It may be necessary to screw
the peg down a little in order for the
peg to locate properly.
The Hex. socket head screw with
washers (in the bag of loose parts), is
used to secure the fence to the table,
through slot ‘C’, into threaded hole ‘D’.
The fence may be set and locked at
any angle. Use a template or angle
gauge if accuracy is required.
3. Attach the Dust/Chip Extraction Chute
A. For Planing
A.1 Lower the Thicknesser Table as far as
possible by turning the table adjustment
handle (see Fig.4) fully anticlockwise.
Fig. 3
Fig. 5
A.2 Pull out the two Locking Keys (arrowed in
Fig.5) and manoeuvre the Chute into the
space beneath the table.
Ensure both Locking keys are pushed firmly
into the slots in the table, shown in Fig.6.
Fig. 6
IMPORTANT: Please note that the Dust Chute MUST ALWAYS be in place, the machine
will not operate if is removed
.
2. Attaching the Table Adjustment Handle
Slide the table adjustment handle (16)
onto the shaft (see Fig. 4).
To raise or lower the table.
Adjust the thicknesser table by turning
the table adjustment handle:
Lower the table - Turn anticlockwise.
Raise the table - Turn clockwise.
Fig. 4