Clarke Woodworker CPT600, Инструкция по эксплуатации и обслуживанию

Страница: 12 / 24

12
Fig. 10
5. Replace in reverse order, and, using a straight edge, ensure the cutting edges
are level and in line with the table when they are at 12 o’clock - see
Fig.10. Tighten the securing screws taking care not to over-tighten or damage
the hex. sockets..
NOTE: It is recommended that sharpening is done professionally, using a jig, as
blades must be sharpened as a pair to ensure they are correctly balanced. This
avoids the possibility of vibration due to inbalanced cutters rotating at speed.
Fig. 10
Periodically.
• Wipe both the infeed and outfeed rollers with a damp cloth to remove all
traces of contaminants.
• Wax the Thicknesser table frequently to ensure a smooth and reliable feed.
• Inspect the kickback pawls before each operation to ensure they are intact
and working properly. They should hang normally and loosely.
• Remove the front cover - 3 dome head nuts, and lightly oil all pivots, linkages
and bearings with good quality machine oil. Ensure the enclosure and all
components are perfectly clean before replacing the cover.