7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
IMPORTANT: NEVER allow the legs to be shorter than the centreline of the
load.
IMPORTANT: Make sure that the hook is directly above the point of lift, which
in turn is directly above the centre of gravity of the load.
the legs should be extended as for as possible during use in order to effect
maximum stability, but must never be extended further than the stop mark,
etched on the upper surface of the leg extension.
RAISING THE JIB
To raise the jib arm, firstly locate the slotted end of the pump handle on to the
hydraulic pressure release nut at the base of the Ram assembly.
Turn the nut clockwise until tight, then remove the handle and locate it in the
pump collar. Pump the ram to raise the jib to the required height.
LOWERING THE JIB
To lower the jib, locate the slotted end of the pump handle on to the pressure
release nut, and very slowly turn in an anticlockwise direction.
The jib will lower under its own weight, the more the valve is opened, the faster
the load will lower. EXERCISE GREAT CARE WHEN LOWERING HEAVY LOADS.
WARNING: WHEN REMOVING AN ENGINE, ENSURE THE VEHICLE IS WELL
SUPPORTED AND SECURE. ALL ANCILLARY PARTS MUST BE
DISCONNECTED, I.E. EXHAUST SYSTEM, SPEEDO CABLE, ELECTRICAL
CABLES AND HOSES, ETC. AND ONLY LIFTING POINTS RECOMMENDED BY
THE VEHICLE MANUFACTURER SHOULD BE USED.
Содержание Strong-Arm CFC1000LR
Страница 16: ......
