Clarke Strong-Arm CFC1000LR, Сборка и инструкция пользователя

Страница: 6 / 16

6
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
6. Connect the support brackets (H), to their upper mountings at either side
of the main support post with bolts (T). Fully tighten all nuts and bolts
assembled used so far.
7. Place the Hydraulic Pump/Ram Assembly (l), (with Ram uppermost), into its
mounting on the Main Support Post. Having lined up the hole in the bracket
with that in the ram assembly, insert bolt (R) and tighten fully. Be careful not
to overtighten and clamp the pump/ram assembly. Allow the Ram
assembly to rest against the support post.
8. Lift the jib (I) into position in its mounting on top of the main support post
and secure tightly with bolt (Q).
9. Raise the jib and manoeuvre the hydraulic ram assembly until the ram
enters the bracket on the jib.
10. Line up the holes in the bracket and ram and insert bolt (R). It may be
necessary to extend the ram by approx 2" to facilitate its location. To do
this, ensure the valve on the side of the ram assembly is closed by turning it
firmly clockwise using the notched end of the pump handle. Pump the
handle until the ram extends by the required amount.
11. Raise the jib to a horizontal position using the hydraulic ram and insert the
Jib Extension (J) to the required length (see OPERATION). Ensure that the
slot at one end of the extension is outermost and on its underside. Secure
using the bolt (R), being careful not to overtighten.
12. Fit the chain and hook assembly (K) to the end of the jib extension by
sliding the end chain link into the slot provided and threading the bolt (5)
through the locating hole and chain link.
13. Finally check to ensure that all nuts are fully tightened and the hydraulic
ram assembly, wheels and castors, all operate freely.
NOTE: DO NOT OVERTIGHTEN ANY SECTION WHICH MAY CAUSE
DISTORTION