Clarke Strong-Arm CFC1000LR, Сборка и инструкция пользователя

Страница: 5 / 16

5
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
ASSEMBLY
PREPARATION
Using a clean not level area, unpack.
check and identity all components
including nuts, bolls and washers. Lay
out the main components roughly as
shown in parts diagram on page 11.
During assembly, nuts and bolts
should only be finger tightened unless
otherwise specified. Final tightening
can be carried out when assembly is
completed.
Where' bolts' are mentioned, it Is assumed that the appropriate washers. lock
washers and nuts are also fitted.
ASSEMBLY
REFER TO PARTS DIAGRAM ON PAGE 11)
1. Locate each Front Leg (B) into the extensions provided on the Rear
Support (A). Ensure the leg extension clamping bolts (O) are on the inside
of the legs.
2. Thread the front leg retaining bolt (N) through the hole in one end of the
support bracket (H) and then through the hole in the front leg, (where the
leg locates over the rear support bracket), thereby locking the leg to the
rear support bracket. Ensure that the bolt (N) is passed through the leg from
the INSIDE, so that when assembled, the support brackets (H) lie between
the front legs.
3. Raise the Support Brackets (H) so that the Extension Support (C) may be
placed over the front legs and secured with bolts (P).
4. Insert the Rear Extension legs (D) into the ends of the rear extension. Insert
the Front Extension Legs (E), into the ends of the front legs (ensure the
wheels are parallel to each other). Set to the required length, ensuring they
are inserted by the same amount, (see Operation). and secure using bolts
(0).
IMPORTANT: The front and rear Extension Legs should NEVER be extended
beyond the 'STOP' mark, etched on their upper faces.
5. Place the Main Support (G) on to the Extension Support (C), over the holes
provided, so that the Hydraulic Ram Assy bracket on the main support is
facing towards the front wheels. Secure using bolts (P).