9
Insert a screwdriver into the slot provided in the centre of the fan, which is at the
rear of the machine, visible through the grille. Turn the fan with the screwdriver to
free the seals.
Water inlet filter
Located behind the inlet Hose Adapter, this filter should be removed for cleaning
after every 10 hours of use (or less if water is contaminated).
Remove the filter by unscrewing the inlet hose adapter and withdrawing the filter
element.
Clean the element with fresh water. To replace, reverse the above procedure,
ensuring that the inlet hose adapter seal is in place.
TROUBLESHOOTING
Fault
Cause
Remedy
Machine will not start
1. No electrical power
1. Check cable, plug, fuse
2. Electrical defect
2. Return to service agent
Motor will not rotate
1. Pump seals dry after
1. Disconnect from electrical
period of storage
and water supply’s and free
seals - refer to Care &
Maintenance, p8
Machine blows fuses
1. Pump seals dry after
1. Free off pump seals
when starting
a period of storage
refer to maintenance p8
2. Hard Start
2. Pull trigger when starting
3. Poor electrical
3. Check supply
supply
4. Motor defective
4. Return to service agent
Machine will not
1. Pump sucking in air
1. Check for leaks in hose
come up to pressure
2. Intake filter blocked
2. Clean filter
3. Defective pump
3. Return to service agent
For Spare Parts and Servicing, please contact your nearest dealer, or
MACHINE MART, on one of the following numbers.
PARTS - 0115 956 1805 SERVICE - 0115 956 1809
Please note that the details and specifications contained herein, are correct at the time of going to print. However,
MACHINE MART reserve the right to change specifications at any time without prior notice.
