NOTE:
1.
In some areas, it may be necessary to ensure that you comply with local
bylaws concerning the use of water from the mains supply, and the disposal
of possibly contaminated water.
2.
Hose, worm drive clips and other accessories are readily available from all
good DIY, Hardware and Garden Supplies Stores.
OPERATION
1.
Make certain the ON/OFF switch, located on the rear panel of the unit, is set
in the OFF position.
2.
Connect the plug to the mains supply, preferably via a Residual Current Device.
3.
Turn the water tap fully on. Remember - NEVER attempt to run the machine
with the water supply disconnected, or turned off.
When starting, you should always adopt the following procedure:
In order to ease the starting process, and to prevent the possibility of blown fuses,
pull the trigger on the lance and hold in that position whilst switching the motor
ON and allowing the pump to develop full pressure.
NOTE: It may be necessary to release the safety latch in order to release the trigger,
by pushing the button, on the right side of the trigger assembly, IN.
You may release the trigger once full pressure is developed. When you do so, the
motor will continue run, and the bypass will come into effect, accompanied by a
noticeable change in motor noise.
As soon as you pull the trigger again, the bypass will close and water at pressure
will be ejected.
WARNING
ENSURE THE OPERATOR IS AWARE THAT WHEN THE TRIGGER IS PULLED, WATER AT
HIGH PRESSURE CAN CAUSE THE LANCE TO KICK
- IT SHOULD THEREFORE BE HELD FIRMLY.
IN ADDITION, CARE MUST BE TAKEN TO ENSURE THAT THE NOZZLE IS NOT AIMED
AT AN AREA WHERE THE WATER JET WILL CAUSE DAMAGE.
i.e. AWAY FROM PEOPLE, ANIMALS, WINDOWS - GREENHOUSES ETC., AND BE
AWARE THAT SPLASH BACK COULD ALSO CAUSE DAMAGE IF THE JET IS
TRAINED ON A NEARBY WALL ETC.
6
