ADDITIONAL PRECAUTIONS FOR ANGLE GRINDERS
1.
It is strongly advised that you wear ear protectors/defenders as the noise level
during operation, depending upon the work being carried out, can exceed
safe working levels.
2.
Always wear a good pair of industrial gloves to avoid potential injury from
sparks and debris.
3.
Do not use the tool if the electric cable, plug or motor is in poor condition.
4.
Keep the mains cable well away from the tool and ensure an adequate electrical
supply is close at hand so that the operation is not restricted by the length of the cable.
5.
Switch the tool OFF immediately the task is completed.
6.
Never allow the ventilation slots in the tool to become blocked.
7.
Do not attempt any electrical repair yourself. Consult a qualified electrician, or
the Clarke Service Department on 0208 988 7400.
8.
DO NOT cut through walls or cavities before checking for hidden electrical
wires or water pipes etc.
9.
Ensure the grinding wheel or cutting disc is fully tightened before use.
10. Do not use the tool in a confined space which may limit body movement.
11. Ensure the wheel/disc is not touching the work when switching ON.
12. Use only wheels/discs having a maximum operating speed of at least 11,000RPM.
13. Check the disc carefully for cracks or damage before operation. Replace
cracked or damaged wheels/discs immediately.
14. Take care not to damage the spindle or wheel flanges as damage to these
parts could result in wheel/disc breakage.
15. ALWAYS hold the tool firmly in BOTH hands.
16. Before using the tool on an actual workpiece, allow it to run briefly, checking for
vibration which could indicate poor balance or installation of the wheel/ disc.
17. Use only wheels/discs designed for their specific function. DO NOT use cutting
discs for grinding metal, or metal grinding wheels for cutting masonry.
18. When grinding, hold the grinder at an angle of 15-30
O
to the work surface.
19. NEVER use excessive force. It should only be necessary to use a little more than
the weight of the tool. If the rotational speed drops abnormally, reduce pressure
immediately. Forcing the tool and excessive pressure can cause dangerous
disc breakage and/or damage to the tool.
20. NEVER use the tool with the guard removed. If the guard becomes damaged,
it should be replaced.
21. NEVER twist the grinder when using Cutting Discs. Take care to ensure sparks
do not fall on to sensitive areas. Be aware of the fire risk from sparks.
22. Never use Wheels/Discs other than 115mm diameter.
23. ALWAYS store and handle abrasive discs according to the manufacturer’s
instructions.
5
