13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4. Place a set square on the table
and up against the blade.
•
Do not touch the extended tips of
the blade teeth with the square.
Lower the blade so as to present
as much blade surface as
possible to the set square.
If adjustment is required, proceed as
follows:
5. Release the locking nut and use
the hex key to turn the 90°
adjustment stop bolt in or out until
the blade is at 90° to the table as
shown by the set square.
6. If the bevel pointer does not
indicate zero on the bevel scale,
loosen the set screw that secures
the pointer and adjust the pointer
as necessary.
CHECK & ADJUST THE 45 DEGREE
STOP
1. Loosen the bevel clamp handle
and lean the saw head as far to
the side as possible (i.e. at 45°).
2. Place a 45° set square on the
table and up against the blade.
NOTE:
Do not touch the tips of the
blade teeth with the square.
3. Loosen the locknut and turn the
45° adjustment stop bolt in or out
until the blade is at 45° to the
table as verified with the square.
4. Adjust the bevel pointer if required as shown previously.
Содержание CMS250S
Страница 28: ......
